ASV Inventions :: Adding a Pro Model Bearing Kit To Your ASV Lever

Adding a Pro Model Bearing Kit To Your ASV Lever

Adding a Pro Model Bearing Kit To Your ASV Lever

 

All ASV levers come with two steel sealed bearings on the main pivot where your lever folds. You can also add bearings to the pivot where your lever rotates on the perch or master cylinder.

You will need to order a “Pro Bearing Kit” from ASV. The cost is $10.00

Click Here to Order Pro Bearing Kit

To install the bearing kit
Step 1: take your ASV lever and with a medium size punch or large Phillips screwdriver, press the steel bushing out of the ASV lever. If you need to use force or a hammer to pound the bushing out, that is O.K. (See Photos 1-3)

Step 2: gently press the two small bearings from your “Pro Bearing Kit” into your ASV lever. If the bearings are loose or do not stay in the hole you can use some loc-tite bolt glue to secure the bearings. Be sure to use a very small amount of loc-tite and do not get any loc-tite in the bearings or they will not operate properly. (See photos 4-5)

 

Copyright © 2000-2017 ASV Inventions